Panelization Calculator
Optimize PCB panel layout for manufacturing
Panel Configuration
Panel Layout Results
Total Boards
12
Layout
4 × 3
Utilization
66.7%
V-Cut Lines
9
Usable Area
240 × 170 mm
Array Size
206.0 × 154.0 mm
Standard Panel Sizes
Depaneling Methods
V-Cut
Clean edges, straight lines only
Tab Route
Irregular shapes, breakaway tabs
V-Cut + Tab
Best of both, complex boards
Method, assumptions & worked example
Formula used by this calculator
W_u = W_panel − 2·rail ; H_u = H_panel − 2·rail
N_x = ⌊(W_u + s_x) / (w + s_x)⌋ ; N_y = ⌊(H_u + s_y) / (h + s_y)⌋
N = max(N_x·N_y, rotated N_x·N_y)
Utilization = N·w·h / (W_panel·H_panel)
- w, h
- single board width and height
- s_x, s_y
- gap between boards (0 for pure V-cut, ≈2 mm for tab routing)
- rail
- tooling/handling rail on each panel edge
Source: Simple rectangular nesting; panel, rail and spacing values follow common fabricator and SMT-line practice (see IPC-7351 / IPC-2221 for board-level clearances). Always confirm the working panel size with your fabricator.
Assumptions & limits
- Rectangular boards only, one orientation per panel (the better of normal and 90° rotated is chosen). Mixed or nested layouts can fit more.
- Rails are applied on all four sides. Many assemblers only need rails on the two conveyor edges, which raises the count.
- Utilization is measured against the full panel including rails, so it is lower than the copper-area yield your fabricator quotes.
- Tab count is a fixed estimate of 8 tabs per board when tab routing is selected.
Worked example (the calculator's default inputs)
Inputs: Board 50 × 50 mm · Panel 250 × 180 mm · Rail 5 mm · Spacing 2 mm × 2 mm
- Usable area = (250 − 2×5) × (180 − 2×5) = 240 × 170 mm
- N_x = ⌊(240 + 2) / (50 + 2)⌋ = ⌊4.65⌋ = 4
- N_y = ⌊(170 + 2) / (50 + 2)⌋ = ⌊3.31⌋ = 3 → 12 boards (rotation gives the same for a square board)
- Utilization = 12 × 2 500 mm² / 45 000 mm² = 66.7 %
Result: 12 boards per panel (4 × 3), 66.7 % panel utilization
Figures are calculated with the formula above, not measured. Field-solver tools and your fabricator's stack-up data take priority for production impedance and current limits.